- No communication with the parking aid module (PAM)
|
- Fuse
- Wiring, terminals or connectors
- PAM
|
|
- The parking aid is inoperative/does not operate correctly
|
- Fuse
- Wiring, terminals or connectors
- Parking aid sensor alignment
- Parking aid switch
- PAM
- Bumper cover
|
|
- Continuous or intermittent tone when no obstacles or fault codes are present (certain obstacles may appear "stealthy" to the system, depending on geometric shape, size and material)
|
- Dirty or iced over parking aid sensor(s)
|
- CLEAN the rear bumper and sensors with high-pressure water.
|
| |
- Parking aid sensor bezel(s) or parking aid sensor(s) locked into the rear bumper incorrectly
|
- INSTALL the parking aid sensor bezel(s) into the rear bumper correctly. INSTALL the parking aid sensor(s) into the parking aid sensor bezel(s) correctly.
|
| |
- Parking aid sensors are not aligned correctly
|
|