Pinpoint Test A: All Power Windows Are Inoperative
- A1 CHECK CIRCUIT CBP47 (GN/BU) FOR VOLTAGE
- Disconnect: LH Front Window Control Switch C504a
- Key in ON position.
- Measure the voltage between LH front window control switch C504a-5, circuit CBP47 (GN/BU), harness side and ground.
Courtesy of FORD MOTOR CO.
- Is the voltage greater than 10 volts?
- YES
: Go to A3.
- NO
: Go to A2.
- A2 CHECK CIRCUIT CBP47 (GN/BU) FOR AN OPEN
- Key in OFF position.
- Disconnect: SJB C2280d
- Measure the resistance between LH front window control switch C504a-5, circuit CBP47 (GN/BU), harness side and SJB C2280d-32, circuit CBP47 (GN/BU), harness side.
Courtesy of FORD MOTOR CO.
- Is the resistance less than 5 ohms?
- YES
: Go to Pinpoint Test H to diagnose the accessory delay relay circuit.
- NO
: REPAIR the circuit. TEST the system for normal operation.
- A3 CHECK CIRCUIT GD133 (BK) FOR AN OPEN
- Disconnect: LH Front Window Control Switch C504b
- Measure the resistance between LH front window control switch C504b-4, circuit GD133 (BK), harness side and ground.
Courtesy of FORD MOTOR CO.
- Is the resistance less than 5 ohms?
- YES
: INSTALL a new LH front window control switch. REFER to Window Control Switch . TEST the system for normal operation.
- NO
: REPAIR the circuit. TEST the system for normal operation.