Turn Signal/Hazard Lamps

The front turn signal lamps are located within the headlamp assemblies. For Taurus and Taurus X, the rear lamps share functionality with the stoplamps (combination stop/turn lamps). For Sable, the rear turn lamps are independent of the stoplamps. When the multifunction switch is placed in the LH or RH TURN positions, the SJB cycles the voltage on and off approximately 80 times per minute. If a front or rear turn bulb is inoperative, the SJB cycles the voltage on and off approximately 160 times per minute.

The hazard switch is located on the center instrument panel finish panel. When the hazard switch is pressed, the SJB cycles the voltage on and off to all the turn lamps approximately 80 times per minute.