DTC P0704: - Clutch Switch Input Circuit
DTC P0704: - CLUTCH SWITCH INPUT CIRCUIT
| Description: | When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set. | ||
| Possible Causes: |
|
||
| Diagnostic Aids: | When the clutch pedal is applied and then released, the switch voltage should cycle. | ||
| Application | Key On Engine Off | Key On Engine Running | Continuous Memory |
| All | GO to Pinpoint Test TA . | - | GO to Pinpoint Test TA . |