Accessory Drive Belt Tensioner

Accessory Drive Belt Tensioner

Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and remove the accessory drive belt from the generator pulley.

3. Remove the 7 pin-type retainers and the RH splash shield.

4. Remove the 3 bolts and the accessory drive belt tensioner.

Installation

1. Install the accessory drive belt tensioner and the 3 bolts.
- Tighten to 11 Nm (97 lb-in).

2. NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.

Working from the top of the vehicle, using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.

3. Install the RH splash shield and the 7 pin-type retainers.