LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Fusion S, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 800 (Automatic Transmission - 5R110W -- F250-F550 Super Duty) >> In-Vehicle Servicing >> Transmission Insulator And Retainer >> Installation

Transmission Insulator And Retainer: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear transmission insulator and lower the transmission onto the crossmember.
    2. Fig 1: Locating Rear Transmission Mount
    GF0006821Courtesy of FORD MOTOR CO.
    NOTE: It may be necessary to raise the back of the transmission slightly in order to install the bolts.
  2. Loosely install the transmission insulator bolts.
    3. Fig 2: Identifying Transmission Support Insulator Bolts
    G03889100Courtesy of FORD MOTOR CO.
  3. Loosely install the transmission insulator nuts.
    4. Fig 3: Identifying Transmission Support Insulator Nuts
    G03889099Courtesy of FORD MOTOR CO.
  4. Tighten the transmission insulator bolts and nuts.
    • Tighten bolts to 94 Nm (69 lb-ft).
    • Tighten nuts to 103 Nm (76 lb-ft).
    5. Fig 4: Locating Transmission Insulator Bolts
    GF0006823Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals