Direct Clutch Assembly: Disassembly

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Soak all friction clutch plates in clean automatic transmission fluid.

Remove the snap ring.

Fig 1: Locating Snap Ring

Courtesy of FORD MOTOR CO.

Remove the direct clutch plates.

Fig 2: Locating Clutch Plates

Courtesy of FORD MOTOR CO.

Using the special tools, remove the snap ring.

Fig 3: Identifying Snap Ring With Special Tools

Courtesy of FORD MOTOR CO.

NOTE: Note the orientation of the return spring.

Remove the direct clutch balance piston and return spring. Discard the direct clutch balance piston.

Fig 4: Locating Clutch Balance Piston And Return Spring

Courtesy of FORD MOTOR CO.

Remove and discard the direct clutch piston.

Fig 5: Locating Direct Clutch Piston

Courtesy of FORD MOTOR CO.

Clean and inspect all components for damage.