| 215 - ELECTRICAL ROUTINE |
| Powertrain Control System |
|
- Electrical inputs/outputs, vehicle wiring harnesses, PCM, Shift Solenoid A (SSA), Shift Solenoid B (SSB), Shift Solenoid C (SSC), Shift Solenoid D (SSD), Shift Solenoid E (SSE), Output Shaft Speed (OSS) sensor and Turbine Shaft Speed (TSS) sensor, transaxle solenoid power control circuit - no voltage at transaxle connector
|
|
| 315 - HYDRAULIC/MECHANICAL ROUTINE |
| Main Control Valve Body |
|
- Plugged solenoid body filter (SSA
filter plate)
|
- Inspect for damage. Install new as required.
|
- Bolts out of torque specification
|
- Tighten bolts to specification.
|
- Gaskets and separator plate - damaged, off location
|
- Inspect for damage. Install new as required.
|
- Forward clutch regulator valve, springs, clips - stuck, damaged, missing, misassembled
|
- Inspect for damage. Repair as required.
|
- Shift solenoid - stuck, damaged
|
- Inspect for damage. Go To PINPOINT TEST A . Repair as required. Activate solenoid using the scan tool. Repair as required.
|
- For diagnosis related to a specific gear, use the scan tool to select the gear
|
- See the following routines:
- Shift 1-2, Routine 220/320
- Shift 2-3, Routine 221/321
- Shift 3-4, Routine 222/322
- Shift 4-5, Routine 223/323
- Shift 5-6, Routine 224/324
|
| Mechanical |
|
- Clutches or seals - damaged or worn
|
- Inspect for damage. Repair or install new as required.
|