LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Other Concerns: Noise/Vibration - Forward Or Reverse

Other Concerns: Noise/Vibration - Forward Or Reverse

NOTE: NVH symptoms should be identified using the diagnostic tools that are available. For a list of these tools, an explanation of their uses and a glossary of common terms, refer to NOISE, VIBRATION & HARSHNESS . Since it is possible any one of multiple systems may be the cause of a symptom, it may be necessary to use a process of elimination type of diagnostic approach to pinpoint the responsible system. If this is not the causal system for the symptom, refer back to NOISE, VIBRATION & HARSHNESS for the next likely system and continue diagnosis.
OTHER CONCERNS: NOISE/VIBRATION - FORWARD OR REVERSE - DIAGNOSTIC ROUTINES

Possible Component Reference/Action
264 - ELECTRICAL ROUTINE 
  • No electrical concerns
 
364 - HYDRAULIC/MECHANICAL ROUTINE 
For Noises/Vibrations That Change With Engine Speed   
  • Converter components
  • Locate source of disturbance. Repair as required.
 
  • Transmission fluid level (low) - pump cavitation.
 
  • Pump assembly.
  • Engine drive accessories
 
  • Transmission fluid cooler tubes grounding out
 
  • Flexplate
For Noises/Vibrations That Change With Vehicle Speed   
  • Engine mounts - loose or damaged
  • Locate source of disturbance and repair as required.
  • Driveline concerns:
    • Halfshaft shudder
    • CV joints
    • Suspension
    • Modifications
 
  • Output/halfshaft splines - worn or damaged
 
  • Turbine Shaft Speed (TSS) sensor - incorrectly installed
  • Inspect for damage. Repair as required.
Other Noises/Vibrations   
  • Main controls - valve resonance
  • Locate source of disturbance and repair as required.
  • Selector lever cable - vibration, grounding
  • Locate source of disturbance and repair as required.
  • Transmission fluid cooler tubes - grounding
  • Locate source of disturbance and repair as required.
  • ABS
  • Power steering pump