Engagement Concern: Delayed/Soft Forward and Reverse

ENGAGEMENT CONCERN: DELAYED/SOFT FORWARD AND REVERSE - DIAGNOSTIC ROUTINES

Possible Component	Reference/Action
209 - ELECTRICAL ROUTINE
Powertrain Control System
Electrical inputs/outputs, Transmission Range (TR) sensor, Transmission Fluid Temperature (TFT) sensor, Turbine Shaft Speed (TSS) sensor, Line Pressure Control (LPC) solenoid, vehicle wiring harnesses, PCM	Run On-Board Diagnostic (OBD). Refer to INTRODUCTION - GASOLINE MODELS for diagnosis. Go To PINPOINT TEST A , Go To PINPOINT TEST B , Go To PINPOINT TEST C and Go To PINPOINT TEST D .
Solenoid Body
Incorrect solenoid body strategy data stored in the PCM	Verify solenoid body strategy data stored in the PCM, download new identification and strategy as necessary. Refer to SOLENOID BODY STRATEGY .
309 - HYDRAULIC/MECHANICAL ROUTINE
Transmission Fluid Level
Low transmission fluid level	Check transmission fluid level and adjust as necessary. Refer to PRELIMINARY INSPECTION .
Transmission fluid condition	Carry out transmission fluid condition check. Refer to PRELIMINARY INSPECTION .
Selector Lever Linkage (Internal/External)
Damaged, out of adjustment	Inspect for damage. Repair as required. Verify selector lever cable adjustment. Refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS .
Incorrect Pressures
Line pressure, LPC pressure - low	Carry out Line Pressure and Stall Speed Tests. Refer to SPECIAL TESTING PROCEDURES . See the Line Pressure Chart for specifications. If pressures are low, check the following possible components: Main Control, Pump Assembly and LPC solenoid.
Transmission Fluid Filter and Seal Assembly
Plugged, damaged, not correctly seated	Inspect for damage. Install a new filter and seal assembly.
Filter, seal - damaged	Inspect for damage. Install a new filter and seal assembly.
Main Controls
Bolts out of torque specification	Tighten bolts to specification.
Gaskets and separator plate - damaged, off location	Inspect for damage. Install new as required.
Seals, manual valve, main regulator valve - missing, damaged or misassembled	Inspect for damage. Repair or install new as required.
Pump Assembly
Bolts out of torque specification	Tighten bolts to specification.
Worn/cross leaks - leaking	Install a new pump assembly.
Components damaged	Inspect for damage. Install new as required.