Selector Lever Knob: Removal

Vehicles with a Transmission Control Switch (TCS) 

1. Remove the selector lever trim ring.
   Fig 1: Locating Selector Lever Trim Ring

   Courtesy of FORD MOTOR CO.
2. Lift the armrest and remove the center console cup holder panel.
   Fig 2: Locating Floor Console Finish Panel

   Courtesy of FORD MOTOR CO.

   All vehicles 

3. Slide the lower selector lever knob bezel downward.
   Fig 3: Locating Lower Selector Lever Knob Bezel Downward

   Courtesy of FORD MOTOR CO.
4. Remove the 2 screws from the selector lever knob.
   Fig 4: Locating Screws From Selector Lever Knob

   Courtesy of FORD MOTOR CO.

   Vehicles without a TCS 

5. Remove the selector lever knob.

   Vehicles with a TCS 

NOTE: Selector lever removed for clarity.
Fig 5: Releasing Selector Lever Bezel Tabs
Courtesy of FORD MOTOR CO.
6. Release the 4 tabs and position the selector lever trim ring aside to gain access to the Transmission Control Switch (TCS) electrical connector.
7. Disconnect the TCS  electrical connector, route the wiring harness out of the selector lever bezel and remove the selector lever knob and knob bezel.
   Fig 6: Locating TCS Electrical Connector

   Courtesy of FORD MOTOR CO.