Front Ride Height Measurement

Fig 1: Identifying Front Ride Height Measurement

Courtesy of FORD MOTOR CO.

ITEM DESCRIPTION CHART

Item	Description
1	Ride height = 2 - 3
2	Measurement 2
3	Measurement 3

NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. The vehicle should have a full tank of fuel.

Position a suitable surface gauge (such as Starrett 57D Surface Gauge) on a flat, level surface, adjust the gauge's arm until the scriber point is located in the center of the forward lower arm bolt.
- Lock the surface gauge in this position.
  
  Fig 2: Adjusting Gauge's Arm Until Scriber Point Is Located In Center Of Forward Lower Arm Bolt
  Courtesy of FORD MOTOR CO.
With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 2).

Fig 3: Measurement Of Surface Gauge Position (Measurement 2)
Courtesy of FORD MOTOR CO.
Position the surface gauge on the same flat, level surface and adjust the gauge's arm until the scriber point is located on the lowest and furthest inboard point of the lower ball joint.
- Lock the surface gauge in this position.
  
  Fig 4: Positioning Surface Gauge On Same Flat
  Courtesy of FORD MOTOR CO.
With the surface gauge positioned on a flat, level surface, record the measurement of the surface gauge position (measurement 3).

Fig 5: Measurement Of Surface Gauge Position (Measurement 3)
Courtesy of FORD MOTOR CO.
Subtract measurement 3 from measurement 2 to obtain the front ride height.
- Refer to SPECIFICATIONS .