Removal and Installation

NOTE: Do not allow the clockspring to rotate while the steering wheel is disconnected or damage to the clockspring may result. If there is evidence that the clockspring has rotated, the clockspring must be recentered. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .

Place the steering wheel in the straight-ahead position and remove the ignition key.
Remove the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
Remove and discard the steering wheel bolt.
- To install, tighten to 47 Nm (35 lb-ft).
Remove the steering wheel.
- Disconnect the steering wheel switches electrical connector from the clockspring.
- Route the 2 driver air bag module electrical connectors and harness through the steering wheel.
  
  Fig 1: Locating Driver Air Bag Module Electrical Connectors And Steering Wheel Harness
  Courtesy of FORD MOTOR CO.
Tape the clockspring center rotor to the outer housing to keep it from rotating.

Fig 2: Locating Clockspring Center Rotor
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
Install the driver air bag module. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .