Power Steering Pump: Removal

NOTE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.

Using a suitable suction device, siphon the power steering fluid from the power steering fluid reservoir.
Remove the 7 pin-type retainers and the RH splash shield.

Fig 1: Locating Pin-Type Retainers
Courtesy of FORD MOTOR CO.
Position the Stretchy Belt Remover on the power steering pump pulley belt as shown.

Fig 2: Positioning Stretchy Belt Remover On Power Steering Pump Pulley Belt
Courtesy of FORD MOTOR CO.

NOTE: Feed the Stretchy Belt Remover on to the power steering pump pulley approximately 90 degrees.

Fig 3: Identifying Stretchy Belt Remover On Power Steering Pump Pulley

Courtesy of FORD MOTOR CO.

Turn the crankshaft clockwise and feed the Stretchy Belt Remover evenly on the power steering pump pulley as shown.
Remove the power steering pump belt.
- Fold the Stretchy Belt Remover under the inside of the power steering pump belt as shown.
- In one quick motion, firmly pull the Stretchy Belt Remover out of the RH fender well, removing the power steering pump belt.
  
  Fig 4: Removing Power Steering Pump Belt
  Courtesy of FORD MOTOR CO.
Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose from the power steering pump.
- Detach the supply hose retainer from the pressure line bracket.
Remove the pressure line bracket-to-engine bolt.
Remove the 3 power steering pump bolts.
Holding the power steering pump with a suitable holding device, disconnect the pressure line fitting-to-power steering pump.

Fig 5: Disconnecting Pressure Line Fitting-To-Power Steering Pump
Courtesy of FORD MOTOR CO.