LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Fluid Cooler >> Removal and Installation

Removal and Installation

NOTE: When repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may occur.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the lower radiator air deflector screws, pin-type retainers and the deflector.
  3. Release the clamps and disconnect the hoses from the power steering fluid cooler.
  4. Remove the 2 bolts and the power steering fluid cooler.
    • To install, tighten to 9 Nm (80 lb-in).
  5. To install, reverse the removal procedure.
  6. Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION .
scientia non olet · About LEMON Manuals