Restraints Control Module (RCM)

WARNING: Do not handle, move or change the original horizontal mounting position of the restraints control module (RCM) while the RCM is connected and the ignition switch is ON. Failure to follow this instruction may result in the accidental deployment of the Safety Canopy® and cause serious personal injury or death.

WARNING: If a vehicle has been in a crash, inspect the restraints control module (RCM) and the impact sensor (if equipped) mounting areas for deformation. If damaged, restore the mounting areas to the original production configuration. A new RCM and sensors must be installed whether or not the air bags have deployed. Failure to follow these instructions may result in serious personal injury or death in a crash.

NOTE: Prior to removal of the Restraints Control Module (RCM), it is necessary to upload module configuration information to the scan tool. This information needs to be downloaded into the new RCM once installed. Refer to MODULE CONFIGURATION .

NOTE: When a new PCM is installed, the air bag warning indicator will illuminate when the ignition is ON. The warning indicator will remain on until PCM configuration is restored. Clear RCM DTCs.

NOTE: This vehicle may be equipped with the SYNC® V2 feature which contains the 911 assist option. Refer to the Owner's Literature.

NOTE: Carrying out Programmable Module Installation (PMI) will not enable the 911 assist option that is disabled. The RCM and Accessory Protocol Interface Module (APIM) must be configured correctly to fully support 911 assist functionality.

The RCM carries out the following functions:

deploys the air bag(s)/safety canopies in the event of a deployable collision.
activates the safety belt buckle pretensioner and safety belt adaptive load limiter retractor to control tension on the safety belt in the event of a deployable collision.
monitors the SRS for faults.
sends a message to the IC module to flash/illuminate the air bag warning indicator if a fault is detected.
communicates through the DLC the current or historical DTCs.

The RCM monitors the SRS for possible faults. If an SRS fault exists, the RCM sends a message to IC module to flash a coded sequence which is called a Lamp Fault Code (LFC) on the air bag warning indicator.

When the ignition is cycled (turned OFF and then ON), the IC module will prove out the air bag warning indicator by lighting for 6 seconds and then turn off. If a current SRS fault exists, the RCM requests illumination of the air bag warning indicator and will remain illuminated for the rest of the ignition cycle. The RCM will also communicate the on-demand (current) and continuous (historical) DTCs through the DLC , to the scan tool. If the RCM requests illumination of the air bag warning indicator and the air bag warning indicator does not function, the IC module will automatically activate an audible chime. The chime is a series of 5 sets of 5 tone bursts. If the chime is heard, the SRS and the air bag warning indicator require repair.

The RCM includes a backup power supply. This feature provides sufficient backup power to deploy the air bags in the event that the ignition circuit is lost or damaged during impact. The backup power supply will deplete its stored energy approximately one minute after power and/or ground has been removed from the RCM .