Removal and Installation

Remove the RH instrument panel side finish panel.

Fig 1: Locating RH Instrument Panel Side Finish Panel
Courtesy of FORD MOTOR CO.
Release the 2 glove compartment bumpers and lower the glove compartment.

Fig 2: Locating Glove Compartment Bumpers
Courtesy of FORD MOTOR CO.
Detach the HVAC module from the bracket.
1. Release the 2 HVAC module bracket clips.
2. Rotate the bottom of the HVAC module outward to detach it from the bracket.
3. Lower the HVAC module to allow access to the electrical connectors.
  
  Fig 3: Removing HVAC Module Bracket Clips
  Courtesy of FORD MOTOR CO.
Disconnect 2 HVAC module electrical connectors and remove the HVAC module.
To install, reverse the removal procedure.