LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Climate Control System - General Information And Diagnostics >> General Procedures >> Refrigerant Oil Adding >> Adding Refrigerant Oil After New Suction Accumulator or Receiver/Drier Replacement

Adding Refrigerant Oil After New Suction Accumulator or Receiver/Drier Replacement

NOTE: This refrigerant oil adding method is to be used when a new suction accumulator or receiver drier only has been installed. If a new A/C compressor and evaporator core orifice or TXV have also been installed due to system contamination, refer to the appropriate heading.
  1. Drill one 12.7 mm (1/2 in) hole in the old suction accumulator or receiver/drier cylinder and drain the oil into a clean measuring cup.
  2. Add the same quantity of new PAG oil, plus the amount collected during refrigerant recovery and 60 ml (2 fl oz).
scientia non olet · About LEMON Manuals