LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> HVAC Climate Control System - General Information And Diagnostics >> General Procedures >> Refrigerant Oil Adding >> Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

Adding Refrigerant Oil After Multiple Component Replacement After A/C System Contamination

NOTE: This refrigerant oil adding method is to be used when a new A/C compressor, suction accumulator or receiver drier and evaporator core orifice or TXV have been installed due to system contamination and the A/C system has been flushed.
NOTE: Service A/C compressors are shipped without refrigerant oil.
  1. Add 60 ml (2 fl oz) directly to the new A/C compressor suction port.
  2. Inject the total vehicle PAG oil capacity minus 60 ml (2 fl oz) to the low-side service port during system charging. For the total PAG oil capacity specification, refer to the SPECIFICATIONS  table.
scientia non olet · About LEMON Manuals