Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the RH cowl side trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Disconnect the 4X4 control module electrical connector.

Fig 1: Identifying 4X4 Control Module Electrical Connector
Courtesy of FORD MOTOR CO.
Disengage the control module and bracket assembly push pins from the mounting holes.
- Discard the retaining pins.
  
  Fig 2: Locating Discard Retaining Pins
  Courtesy of FORD MOTOR CO.
Remove the 4X4 control module and bracket assembly from the vehicle.
To install, reverse the removal procedure.