LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Removal

Stub Shaft Seal: Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: The Rear Drive Unit (RDU) does not have stub shaft pilot bearings. It has stub shaft seals only.
  1. Remove the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS .
  2. Using the Torque Converter Fluid Seal Remover and Slide Hammer, remove the stub shaft seal.
    Fig 1: Removing Stub Shaft Seal
    G06065011Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals