LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Stub Shaft Seal >> Installation

Stub Shaft Seal: Installation

WARNING: This page is about a different variant/trim than selected.
    NOTE: Lubricate the new stub shaft seal with grease.
    Fig 1: Tapping Stub Shaft Pilot Bearing Housing Seal
    G06065012Courtesy of FORD MOTOR CO.
  1. Using the Front Axle Oil Seal Installer and Adapter (Handle) for 303-224, install the stub shaft pilot bearing housing seal.
  2. Install the halfshaft assembly. For additional information, refer to REAR DRIVE HALFSHAFTS .
scientia non olet · About LEMON Manuals