Drive Pinion Seal: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Fig 1: Tapping Pinion Seal

G06065003

Courtesy of FORD MOTOR CO.

Using the Pinion Seal Replacer, install the seal.

NOTE: Lubricate the pinion flange with premium long-life grease.

Fig 2: Identifying Index Marks Location

G06065000

Courtesy of FORD MOTOR CO.

Line up the index marks and position the pinion flange.
Using the Drive Pinion Flange Holding Fixture, install the new pinion nut.

Fig 3: Tightening Drive Pinion Flange Nut
Courtesy of FORD MOTOR CO.
- Tighten to 244 Nm (180 lb-ft).
- Install the driveshaft. For additional information, refer to DRIVESHAFT