Output Shaft Seal: Removal

WARNING: This page is about a different variant/trim than selected.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the exhaust flexible pipe. For additional information, refer to EXHAUST SYSTEM .

NOTE: Index-mark both the driveshaft flanges for installation.

Remove the 4 driveshaft-to-Power Transfer Unit (PTU) output flange bolts. Disconnect the driveshaft from the PTU and position it aside.
- Using mechanic's wire, support the driveshaft.

NOTE: Rotational torque of the PTU rear output shaft flange must be measured and recorded using a Nm (lb-in) torque wrench for correct pinion bearing preload when reassembled. This will be the torque-to-turn measurement.

Fig 1: Locating PTU Output Shaft And Using Suitable Torque Wrench

Courtesy of FORD MOTOR CO.

Using a suitable torque wrench, measure and record the rotational torque of the PTU output shaft.
Using the Drive Pinion Flange Holding Fixture, hold the output pinion flange. Remove and discard the pinion nut.

Fig 2: Locating Discard Pinion Nut
Courtesy of FORD MOTOR CO.

NOTE: Index-mark the output pinion flange to the pinion shaft.

Fig 3: Identifying Output Pinion Flange And Using Output Flange Remover

Courtesy of FORD MOTOR CO.

Using the Output Flange Remover, remove the output pinion flange.
Remove and discard the output shaft seal deflector.
Remove and discard the output shaft seal.
Remove and discard the collapsible spacer.