Coolant Pump Belt: Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Install the coolant pump belt on the coolant pump pulley and position it on the camshaft pulley.
- Rotate the crankshaft clockwise to seat the water pump belt on the camshaft pulley.
- Install the RH splash shield and the bolts.
- Tighten to 7 Nm (62 lb-in).
CAUTION:
Do not use any screwdrivers, pliers or other metal objects that could cause damage to the belt or camshaft pulley while installing the belt.