LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 964 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Servicing >> Oil Level Indicator and Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the 5 bolts and the RH splash shield.
    • To install, tighten to 9 Nm (80 lb-in).
  3. Remove the oil level indictor.
  4. Remove the 2 bolts and the oil level indicator tube.
    • To install, tighten to 10 Nm (89 lb-in).
  5. Remove and discard the oil level indicator tube O-ring seal.
  6. To install, reverse the removal procedure.
    • Lubricate a new O-ring seal with clean engine oil.
scientia non olet · About LEMON Manuals