Removal And Installation
WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
- Remove the 5 bolts and the RH splash shield.
- To install, tighten to 9 Nm (80 lb-in).
- Disconnect the oil pressure sender electrical connector.
- Remove the oil pressure sender.
- To install, tighten to 15 Nm (11 lb-ft).
- To install, reverse the removal procedure.
- Apply thread sealant to the oil pressure sender threads.