LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 956 (Windows And Glass) >> Diagnostic Tests >> Glass, Frames and Mechanisms >> Pinpoint Tests >> Pinpoint Test B: A Single Power Window Is Inoperative - LH Front Window >> Pinpoint Test B: A Single Power Window Is Inoperative - LH Front Window

Pinpoint Test B: A Single Power Window Is Inoperative - LH Front Window

WARNING: This page is about a different car, the 2007 Mercury Mariner and 2007 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. B1 CHECK THE POWER WINDOW DOWN OPERATION 
    • Key in OFF position.
    • Disconnect: LH Front Window Motor C524
    • Key in ON position.
    • Fig 1: Checking Circuit For Voltage
      GF0023754Courtesy of FORD MOTOR CO.
    • While operating the LH front window control switch, measure the voltage between LH front window motor C524-b, circuit 992 (WH/BK), harness side and LH front window motor C524-a, circuit 903 (RD), harness side.
    • Is the voltage greater than 10 volts while operating the LH front window control switch in the down direction? 
    1. YES  : INSTALL a new window regulator and motor. REFER to Window Regulator - Front Door . TEST the system for normal operation.
    2. NO  : Go to  B2.
  2. B2 CHECK CIRCUITS 992 (WH/BK) AND 903 (RD) FOR AN OPEN 
    • Key in OFF position.
    • Disconnect: LH Front Window Control Switch C508
    • Fig 2: Checking Circuits For Open
      GF0023755Courtesy of FORD MOTOR CO.
    • Measure the resistance between LH front window control switch C508-4, circuit 992 (WH/BK), harness side, and LH front window motor C524-b, circuit 992 (WH/BK), harness side; and between LH front window control switch C508-9, circuit 903 (RD), harness side, and LH front window motor C524-a, circuit 903 (RD), harness side.
    • Are the resistances less than 5 ohms? 
    1. YES  : INSTALL a new LH front window control switch. REFER to Window Control Switch . TEST the system for normal operation.
    2. NO  : REPAIR the circuit(s) in question. TEST the system for normal operation.