LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 944 (Manual Transaxle/Transmission And Clutch - General Information) >> Diagnostic Tests >> Manual Transmission and Clutch >> Pinpoint Tests >> Pinpoint Test E: Clutch Pedal Pulsation

Pinpoint Test E: Clutch Pedal Pulsation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. E1 CHECK THE CLUTCH PEDAL PULSATION 
    • Key in START position.
    • With the transmission in NEUTRAL, slowly press the clutch pedal.
    • Does the clutch pedal pulsate while being pressed? 
    1. YES  : Go to  E2.
    2. NO  : VERIFY customer concern. Go to Symptom Chart  if necessary.
  2. E2 INSPECT THE CLUTCH PRESSURE PLATE 
    • Remove the clutch pressure plate. Refer to CLUTCH .
    • Inspect the clutch pressure plate for damage.
    • Are there any signs of damage present on the clutch pressure plate? 
    1. YES  : INSTALL a new clutch pressure plate. REFER to CLUTCH .
    2. NO  : Go to  E3.
  3. E3 INSPECT THE CLUTCH DISC 
    1. YES  : Go to  E4.
    2. NO  : INSTALL a new clutch disc. REFER to CLUTCH .
  4. E4 INSPECT THE FLYWHEEL 
    • Inspect the flywheel for damage and runout.
    • Is flywheel OK? 
    1. YES  : VERIFY customer concern. CONDUCT a diagnosis of other suspect components.
    2. NO  : INSTALL a new flywheel as necessary. REFER to CLUTCH . TEST the system for normal operation.
scientia non olet · About LEMON Manuals