LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 943 (Automatic Transmission Cooling) >> Removal And Installation >> Transmission Fluid Cooler Tubes - 4.0L >> Installation

Transmission Fluid Cooler Tubes - 4.0L: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the transmission fluid cooler inlet and outlet tubes and the bracket onto the engine.
    • Tighten to 20 Nm (15 lb-ft).
  2. Connect the transmission fluid cooler inlet and outlet tubes to the transmission.
    • Tighten to 28 Nm (21 lb-ft).
  3. Connect the auxiliary transmission fluid cooler hoses and clamps to the transmission fluid cooler inlet and lower inlet tubes.
  4. Connect the transmission fluid cooler lower inlet and outlet tubes to the radiator.
    • Tighten to 28 Nm (21 lb-ft).
scientia non olet · About LEMON Manuals