LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 942 (Instrument Cluster System And Panel Illumination) >> Removal And Installation >> Instrument Panel Dimmer Switch >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the radio. For additional information refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
  2. Remove the center instrument panel finish panel.
    • Remove the 2 screws.
    • Disconnect the electrical connectors.
  3. Remove the 2 bolts and position aside the hood latch release handle.
  4. Remove the 2 screws and remove the instrument panel steering column cover.
  5. Remove the 5 bolts and the lower instrument panel reinforcement.
    • To install, tighten to 11 Nm (8 lb-ft).
  6. If equipped, position the column-mounted transmission range selector lever to the lowest position.
  7. Remove the instrument cluster finish panel.
    • Remove the 5 screws.
    • Disconnect the electrical connectors.
  8. Remove the 2 screws and the instrument panel dimmer switch.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals