Disabling Unlimited Key Mode

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: By disabling the unlimited key mode with a random 8-digit number, the previous access code no longer operates the vehicle.

From the scan tool, follow the on-screen instructions to ENTER SECURITY ACCESS. For additional information, refer to Anti-Theft Security Access in this article.
Select: "unlimited key mode OFF" and press the tick mark.
Select: "Ignition Key Code Erase" and press the tick mark.
Disconnect the scan tool and turn the ignition switch to OFF.
Insert the first PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.
Turn the first PATS key to the OFF position and remove the key from the ignition lock cylinder.
Insert the next PATS key into the ignition lock cylinder and turn the key to the ON position for 3 seconds.

NOTE: With the unlimited key mode turned off, a maximum of 8 keys can be programmed into the instrument cluster using the Key Programming Using Two Programmed Keys procedure in this article. The PID SPAREKEY must be enabled.

If it is desired to program additional key(s), refer to Key Programming Using Two Programmed Keys in this article for each additional key that needs to be programmed. The PID SPAREKEY must be enabled.