Key Programming Switch State Control
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool |
NOTE:
The spare key programming switch is a programmable switch which provides the capability to enable/disable the normal customer spare key programming procedure detailed in the Owner's Literature. It must read ENABLE if more than 2 keys need to be programmed into the instrument cluster. For additional information, refer to Key Programming Using Two Programmed Keys procedure in this article. This programmable switch is provided as a convenience for rental company fleets or other fleet purchasers who may not want the spare key programming procedure available to the vehicle driver.
NOTE:
The spare key programming switch state can be viewed with the instrument cluster PID SPAREKEY.
NOTE:
If the SPAREKEY PID reads ENABLE, up to 8 keys total can be programmed into the instrument cluster. For additional information, refer to Key Programming Using Two Programmed Keys procedure in this section. If the SPAREKEY PID reads DISABLED ONLY , the Key Programming Using Two Programmed Keys procedure will not function. This PID is set to ENABLE when the vehicle is built. This switch does not affect the Key Programming Using Diagnostic Equipment procedure, the Spare Key Programming - Unlimited Key Mode, or the Spare Key Programming - Using Diagnostic Equipment procedures.
- Insert a programmed PATS key into the ignition lock cylinder and turn the key from the OFF position to the ON position.
- Select instrument cluster from the scan tool menu. Follow the anti-theft security access procedure to obtain security access. For additional information, refer to Anti-Theft Security Access in this section.
- From the scan tool menu toggle: SPARE KEY PROGRAMMING SWITCH selection to the desired setting:
- ENABLE - Spare Key Programming Procedure is accessible.
- DISABLE - Spare Key Programming Procedure is not accessible.
- Exit from the scan tool menu.
NOTE:
The default setting on delivery of all new vehicles is ENABLE.
NOTE:
The spare key programming procedure is available in order to program more than 2 keys, but no more than 8 keys into the PATS using the Key Programming Using Two Programmed Keys procedure in this article.