Parking Brake

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Check the operation of the parking brake system with the vehicle on a hoist and the parking brake control fully released. Check for any damaged cables and install new components as necessary. Check the rear brake adjustment or carry out the brake system diagnosis. Refer to PARKING BRAKE AND ACTUATION .

VISUAL INSPECTION CHART

Mechanical	Electrical
Brake master cylinder Brake caliper piston Brake discs Wheel bearings Brake pads Brake shoes and linings Brake drum Power brake booster Brake pedal linkage Booster vacuum hose Tires Foreign material	Parking brake switch Damaged or corroded wiring harness Brake master cylinder fluid level switch Stoplight switch

For low or spongy brake pedal concerns:

Check for fluid leaks and repair as necessary.
Check and, if necessary, refill the brake master cylinder reservoir.
Bleed the brake system and retest the brake pedal feel.

For slow or incomplete brake pedal return concern:

Inspect for binding, damage, correct installation or interference at the brake pedal.
Check the power brake booster for binding, damage and correct installation.