Brake Pads
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
It is not required to install new brake pads if friction material properties are within guidelines. It is also not required to install new brake pads when the brake discs are machined.
- Remove the brake pads. Refer to FRONT DISC BRAKE .
- Inspect and measure the thickness of the brake pad friction material.
- Install new brake pads if the thickness of the friction material is less than 3.0 mm (0.11 in). Refer to FRONT DISC BRAKE .
- Compare all 4 front or rear pads for uneven wear. Install new brake pads if the thickness of the friction material varies from pad to pad by more than 2.0 mm (0.07 in). Refer to FRONT DISC BRAKE .
- Install new brake pads if there are missing chunks or cracks in the lining through to the backing plate. Refer to FRONT DISC BRAKE .
- If the friction material shows taper wear (i.e. the thickness varies by more than 3.0 mm (0.11 in) in any direction), verify the caliper guide pins are functioning correctly. Refer to Brake Caliper Guide Pins .