LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 929 (Evaporative Emissions System) >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the scan tool, run the evaporative emissions (EVAP) system test.
    2. NOTE: Some small leaks may not be detected using the EVAP system test. If the system has passed the test but a leak is still suspected, then proceed to Phase 2.
  2. If the EVAP system failed the EVAP system test, then proceed to Phase 2.
scientia non olet · About LEMON Manuals