LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Emission Control System) >> Removal And Installation >> Exhaust Manifold to Exhaust Gas Recirculation (EGR) Valve Tube - 4.0L SOHC >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the push pin retainer from the differential pressure feedback exhaust gas recirculation (EGR) sensor.
  2. Disconnect the different pressure feedback EGR sensor from the hoses and position aside.
  3. Loosen the fittings and remove the EGR tube.
    • To install, tighten to 50 Nm (37 lb-ft).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals