LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 928 (Emission Control System) >> Removal And Installation >> Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor - 3.0L and 4.0L SOHC

Differential Pressure Feedback Exhaust Gas Recirculation (EGR) Sensor - 3.0L and 4.0L SOHC

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the push pin retainer from the differential pressure feedback exhaust gas recirculation (EGR) sensor.
  3. Disconnect the differential pressure feedback EGR sensor electrical connector.
  4. Remove the differential pressure feedback EGR sensor from the hoses.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals