LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 920 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Tailgate Latch Remote Control >> Removal

Tailgate Latch Remote Control: Removal

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 8 screws and the tailgate access cover.
    • To install, tighten to 5 Nm (44 lb-in).
  2. Open the tailgate latch actuating rod retainers and disconnect the tailgate latch actuating rods from the tailgate latch remote control.
  3. Remove the 2 tailgate latch remote control nuts.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Remove the tailgate latch remote control.
    5. NOTE: Prior to installation, remove the slack in the tailgate latch release links by pulling the tailgate latch release links to the center of the tailgate. Close the plastic clip over the thread of the tailgate latch release links.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals