LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Supplemental Inflatable Restraint System) >> Removal And Installation >> Front Impact Severity Sensor >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.


    NOTE: Make sure the radiator support and front impact severity sensor mating surfaces are clean and free of foreign material.
    NOTE: Note position of locator tab on sensor bracket for installation.
  1. Remove the front impact severity sensor bolt.
    • To install, tighten to 12 Nm (9 lb-ft).
  2. Disconnect the front impact severity sensor electrical connector and remove the sensor.
  3. To install, reverse the removal procedure.
  4. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering  in the General Procedures portion of this section.
scientia non olet · About LEMON Manuals