LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 913 (Supplemental Inflatable Restraint System) >> General Procedures >> Inspection and Repair After a Supplemental Restraint System (SRS) Deployment >> All vehicles

All vehicles

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to the correct removal and installation procedure for all SRS components being installed.
  1. When any deployable device or combination of devices are deployed and/or the restraints control module (RCM) has the DTC B1231 (Event Threshold Exceeded) in memory, the repair of the vehicle's SRS is to include the removal of all deployed devices and the installation of new deployable devices, the removal and installation of new impact sensors, and the removal and installation of a new RCM. DTCs must cleared from all required modules after repairs are carried out.


  1. When any damage to the impact sensor mounting points or mounting hardware has occurred, repair or install new mounting points and mounting hardware as needed.
  2. When the driver air bag module has deployed, a new clockspring must be installed.
  3. New driver and/or front passenger safety belt systems (including retractors, buckles and height adjusters) must be installed if the vehicle is involved in a collision that results in deployment of the driver and/or front passenger safety belt pretensioners. For additional information, refer to SAFETY BELT SYSTEM article.
  4. Inspect the entire vehicle for damage, including the following components:
    • Steering column (deployable column if equipped)
    • Instrument panel knee bolsters and mounting points
    • Instrument panel braces and brackets
    • Instrument panel and mounting points
    • Seats and seat mounting points
    • Safety belts, safety belt buckles and safety belt retractors. For additional information, refer to SAFETY BELT SYSTEM article
    • SRS wiring, wiring harnesses and connectors
  5. After carrying out the review and inspection of the entire vehicle for damage, repair or install new components as needed.
scientia non olet · About LEMON Manuals