LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Seat System) >> Removal And Installation >> Seat Track - Bucket and 40 Percent >> Removal >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the affected seat. For additional information, refer to Seat - Front  in this article.
  2. Remove the affected seat backrest assembly. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent  this section.


  1. Remove the seat track assist spring.
    Fig 1: Locating Seat Track Spring
    GF0008555Courtesy of FORD MOTOR CO.
  2. Remove the 4 seat track-to-cushion frame bolts and remove the cushion assembly.
  3. Remove the seat track adjustment handle.
    Fig 2: Locating Seat Track Adjustment Handle
    GF0008557Courtesy of FORD MOTOR CO.
    • Remove one side of the seat track adjustment handle at a time.
  4. Release the cushion trim cover rear J-clip.
    Fig 3: Locating Cushion Trim Cover Rear J-Clip
    GF0008558Courtesy of FORD MOTOR CO.
  5. Remove the 8 rail-to-seat track nuts and separate the seat track rails from the seat track.
scientia non olet · About LEMON Manuals