Seat Track - 60 Percent: Removal
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which increases the risk of serious personal injury or death.
NOTE:
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE:
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Remove the seat. For additional information, refer to Seat - Front in this article.
- Remove the 60 percent seat armrest. For additional information, refer to Seat Armrest - 60 Percent in this article.
- Remove the 60 percent seat backrest assembly. For additional information, refer to Seat Backrest - Front, 60 Percent in this article.
- Remove the seat track assist spring.
- Remove the seat track adjustment handle.
- Remove one side of the seat track adjustment handle at a time.
- Remove the 4 seat track-to-cushion frame bolts and remove the seat track from the seat cushion frame.
- Remove the 8 rail-to-seat track nuts and separate the seat track rails from the seat track.