All seats

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Install the backrest assembly.
Install the inboard rear backrest-to-cushion bolt.

Fig 1: Locating Inboard Rear Backrest-To-Cushion Bolt
Courtesy of FORD MOTOR CO.
- Tighten to 25 Nm (18 lb-ft).

Install the inboard front backrest-to-cushion bolt.

Fig 1: Locating Front Inboard Backrest Recliner Bolt
Courtesy of FORD MOTOR CO.
- Tighten to 25 Nm (18 lb-ft).
Install the inboard seat backrest latch release cable end and swivel and install the cable anchor.

Fig 2: Locating Inboard Recliner Cable Anchor And Recliner Cable
Courtesy of FORD MOTOR CO.
Install the 2 outboard backrest-to-cushion bolts.
- Tighten to 25 Nm (18 lb-ft).
Position the trim cover flap and install the outboard pin-type retainer.

Fig 3: Locating Outboard Pin-Type Retainer
Courtesy of FORD MOTOR CO.
Install the outboard seat backrest latch release cable end and swivel and install the cable anchor.

Fig 4: Locating Outboard Recliner Cable
Courtesy of FORD MOTOR CO.
Position the side shield and install the 2 clips (1 shown).

Fig 5: Locating Rear Side Shield Clips
Courtesy of FORD MOTOR CO.
Install the 2 side shield screws.
Install the backrest recliner handle and screw.
Install the 60 percent bench armrest. For additional information, refer to Seat Armrest - 60 Percent in this article.
Install the 60 percent bench seat. For additional information, refer to Seat - Front in this article.