Seat Armrest - 60 Percent: Installation

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Install the LH and RH armrest brackets to the armrest and install the 2 armrest pivot bolts.
- Tighten to 11 Nm (8 lb-ft).
Slide on the LH inner/outer and RH inner/outer trim covers and clip in place (RH side shown).
Install the armrest assembly and install the 2 LH and 2 RH armrest bracket-to-seat frame bolts.

Fig 1: Installing Armrest Bracket Cover
Courtesy of FORD MOTOR CO.
- Tighten to 25 Nm (18 lb-ft).
Position the seat cushion foam pad and seat cover down.
Position the material around the child safety seat tether anchor and fasten the rear J-clip below the armrest.
- Route the trim flap through the child safety seat tether anchor.
  
  Fig 2: Locating Trim Flap Through Child Safety Seat Tether Anchor
  Courtesy of FORD MOTOR CO.
Fasten the J-clips and fasten the underside hook-and-loop strip.

Fig 3: Locating J-Clips & Underside Hook-And-Loop Strip
Courtesy of FORD MOTOR CO.
Install the pin-type retainer and fasten the rear hook-and-loop strip.

Fig 4: Locating Pin-Type Retainer & Rear Hook-And-Loop Strip
Courtesy of FORD MOTOR CO.
Install the safety belt buckle pretensioner and install the nut.
- Tighten to 40 Nm (30 lb-ft).
Route the wiring harness to the cushion.
- Route the wiring harness.
- Fasten the wiring harness and electrical connector pin-type retainers.
  
  Fig 5: Locating Electrical Connector Pin-Type Retainers
  Courtesy of FORD MOTOR CO.
- Connect the seat position sensor electrical connector.
Install the 2 cup holder mounting screws and attach the cup holder.
- Tighten to 7 Nm (62 lb-in).
Install the 60 percent bench seat. For additional information, refer to Seat - Front in this article.