Removal And Installation
WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the lower rear seat trim panel.
- Remove the pin-type retainers.
- Remove the lower rear seat trim panel.
- Remove the 5 rear seat-to-floor bolts.
- To install, tighten to 23 Nm (17 lb-ft).
- Remove the safety belt bolt and remove the rear seat.
- To install, tighten to 40 Nm (30 lb-ft).
- To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.