LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Seat System) >> Removal And Installation >> Seat - Front >> Installation >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat in the vehicle.
  2. Connect the seat electrical connector.


  1. Position the seat fully rearward and install the front inboard seat-to-floor bolt.
    • Tighten to 55 Nm (41 lb-ft).
  2. Install the front outboard seat-to-floor bolt.
    • Tighten to 55 Nm (41 lb-ft).
  3. Position the seat fully forward and install the rear inboard seat-to-floor bolt.
    • Tighten to 55 Nm (41 lb-ft).
  4. Install the rear outboard seat-to-floor bolt.
    • Tighten to 55 Nm (41 lb-ft).
    • Make sure the safety belts and buckles are accessible to the occupants after installation.
  5. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM article.
scientia non olet · About LEMON Manuals