60 percent seat

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: SuperCab and regular cab safety belts route differently, make sure of correct routing.

Fig 1: Routing Center Safety Belt Buckle

Courtesy of FORD MOTOR CO.

Position the seat fully forward and route the front center safety belt buckle through the locating strap on the side of the seat.
Install the front center safety belt bolt.

Fig 2: Locating Center Safety Belt Buckle Anchor Bolt
Courtesy of FORD MOTOR CO.
- Tighten to 55 Nm (41 lb-ft).
- If equipped, slide the front center safety belt bolt cover on the front center safety belt and position in place.