Passenger seat

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Note position of wire routing for installation.

Fig 1: Locating Seat Wiring Harness Retainer Clip & Seat Wiring Harness Connector

Courtesy of FORD MOTOR CO.

Release the seat wiring harness retainer clip and detach the seat wiring harness connector from the seat cushion frame.

NOTE: Note position of wire routing for installation.

Fig 1: Locating Seat Wiring Harness Routing Clips & Seat Cushion Frame

Courtesy of FORD MOTOR CO.

Release the 2 seat wiring harness routing clips from the seat cushion frame.
Release the pressure sensor bracket retainer and slide the pressure sensor off the bracket.

Fig 2: Locating Pressure Sensor Bracket Retainer & Pressure Sensor
Courtesy of FORD MOTOR CO.
Remove the OCSM.
- Remove the 2 screws from the OCSM.
  
  Fig 3: Locating Screws & OCSM
  Courtesy of FORD MOTOR CO.
- Release the OCSM bracket retainer and slide the OCSM off the bracket.

CAUTION: A production occupant classification sensor (OCS) bladder is shown. An OCS service kit will have the OCS bladder attached to the seat cushion foam pad. Do not separate the OCS bladder from the seat cushion foam pad. Failure to do so can result in component failure.

Fig 4: Locating OCS Bladder Pin-Type Retainers

Courtesy of FORD MOTOR CO.

Release the 3 OCS bladder pin-type retainers from the seat cushion frame.

NOTE: Note position of wire routing for installation.

Route the OCS bladder hose and pressure sensor, OCSM and seat wiring harness out through the seat cushion frame opening.