LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2009 >> Flex Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 911 (Seat System) >> Disassembly And Assembly >> Seat Cushion - Front, Bucket and 40 Percent >> Disassembly >> All seats

All seats

WARNING: This page is about a different car, the 2007 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seat. For additional information, refer to Seat - Front  in this article.
  2. Remove the front seat backrest. For additional information, refer to Seat Backrest - Front, Bucket and 40 Percent  in this article.
  3. Release the cushion trim cover rear J-clip from the seat cushion.


  1. Remove the 4 seat track-to-cushion frame bolts and remove the seat track assembly from the cushion frame.


    NOTE: Note routing of the seat backrest latch release cable through the seat cushion frame.
    Fig 1: Locating Seat Back Latch Release Cable And Retainer
    GF0008583Courtesy of FORD MOTOR CO.
  1. Detach the pin-type retainer and remove the backrest latch release cable.
  2. Release the remaining cushion trim cover J-clips.
    Fig 2: Locating Cushion Trim Cover J-Clips
    GF0008553Courtesy of FORD MOTOR CO.
    • If driver seat, remove the cushion frame from the foam pad and cushion trim cover.
    3. CAUTION: An occupant classification sensor (OCS) system service kit will have the OCS bladder attached to the seat cushion foam pad. Do not separate the OCS bladder from the seat cushion foam pad. Failure to do so may result in component failure.
    Fig 3: Locating Hog Rings
    GF0008554Courtesy of FORD MOTOR CO.
  3. Remove all rows of hog rings and remove the cushion trim cover.
scientia non olet · About LEMON Manuals